The steering mechanism is composed of a steering motor, a gear drive mechanism, a connecting rod, a steering mechanism and a telescopic clip. The gear on the output shaft of the steering motor is connected with the main drive gear through the medium wheel, and the main drive gear engages with the rack on the mechanical arm assembly bracket. At the top of the main drive gear spindle, the crank is fixed, the crank is connected to one end of the two parallel links, and the other end of the two parallel links is connected to the gear.
The gear is connected with the missing tooth gear through the column type and the missing gear is fixed with the clamp. The paper wallet is composed of multiple sections, which are positioned through the pull rod and the dead point. The end of the lower pull is connected with the clamp of the clamp, the upper rod and the clamp are connected with the clamp, the other end of the upper and lower lever is twisted together, and the pull rod and clamp are positioned through the pull spring. In the manipulator assembly, there are three positions of the control steering manipulator.
Currency adjustment mechanism before and after the adjustment device, motor through the gear connected to the camshaft, the CAM on the camshaft is located in the manipulator assembly bracket slot on both sides of the plate, light control is set in one side of the mobile position of the camshaft control light barrier; The right and left adjustment device of the currency adjustment mechanism is that the motor is connected with the swing chute through the crank, and the drawing plate connected with the roller in the swing groove is fixed on the mechanical arm assembly bracket; On the axis of the swing chute, there is a light-control panel that controls the moving position.
Compaction mechanism is a bundle of money at a fixed pattern in the rack of the worm gear deceleration, reducer worm connected to the motor, worm gear speed reducer of the spindle and screw connection, located in the bar, wire mother under the beam on the guide pillar and beam connection;
The viscous motor of the lower viscous system is connected to the camshaft through the transmission mechanism, and the CAM on the camshaft is in contact with the top belt and the guide strip. The cutting CAM is in contact with the cutting belt and the compression slider; The top belt CAM is in contact with the top strip slider; The heating CAM is in contact with the slider of the control heater. The sliding plate CAM is in contact with the sliding block of the sliding plate. Each slider is set with a reset spring, and the motor shaft is equipped with an optical control panel.
The cross sticking system is attached to the paper money. The motor is connected to the camshaft by the gear pair, and the heater CAM on the camshaft is connected to the heater by the u-shaped swing rod, connecting rod and swing plate. The hammer CAM is connected by a u-shaped swing rod and a connecting rod with a pressure hammer; The heater and pressure hammer are set with reset spring;
Pulley automatic take-up mechanism is composed of spindle, end cover and spring and pulley, spindle fixed on the frame of the curved plate, wheeled through the heart shaft end cover, suit, near the plate inside the end cover of setting one energy storage spring, one end of the spring fixed on the plate, the other end with end cover connected by friction pair;
Each action position of the baling machine is set with an optical control controller, the optical control system is connected with the control system, and the display screen of the control system has the mark and symbol showing the position of the light control tube. A safety control device consisting of a light control tube is set up on the front of the machine. The heater of the adhesive tape mechanism is a fast heater, which consists of a folded resistive sheet and a copper conductive plate. There is insulation between the resistance plates and the copper conductive plate is welded to the two ends of the resistance chip.
